Watchguard 525 + 2Y LIVESECURITY Specifications download pdf (Page 9)

Hardware Guide 7

Hardware Specifications

Safety Notices

All WatchGuard products are designed and tested to meet strict safety requirements. These requirements

include product safety approvals and other global compliance standards. Read these instructions carefully

before you operate the product, and refer to them as needed for continued safe operation of your product.

Product Safety Certification

The WatchGuard product is safety certified for these standards:

o CAN/CSA C22.2 No.60950-1-07

o IEC 60950-1, Second Edition

o UL 60950-1, Second Edition

Safety Warning

o Do not place objects on the power cord.

o Do not obstruct the ventilation openings. These openings prevent overheating of the XTM device.

o Never push objects of any kind into slots or openings on this equipment. If you make contact with a

voltage point or short out a part, it can result in fire or electrical shock.

o If the equipment is supplied with a three-conductor AC power cable, the power cable must be

plugged in to an approved three-contact electrical outlet with the grounding wire connected to an

electrical ground (safety ground) at the power outlet.

o When you remove or install an appliance, follow the general installation safety instructions provided

in this Hardware Guide to avoid injury or damage to the device.

o The lithium battery used in the security appliance may not be replaced by the user. Return the

appliance to a WatchGuard authorized service center for replacement with the same or equivalent

type recommended by the manufacturer. If, for any reason, the battery or security appliance must be

disposed of, do so following the battery manufacturer’s instructions.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Watchguard 525 + 2Y LIVESECURITY Specifications Page 9