Watchguard Wireless Router User's Guide download pdf (Page 106)

Configuring Firewall Settings

92 WatchGuard Firebox X Edge

Welcome

The first screen tells you about the wizard and the information

you must have to complete the wizard.

Service Name

On this screen, type a name to identify the service.

Protocols and Ports

Set the protocol and ports to assign to this traffic rule.

Traffic Direction

Identify if this is an incoming or outgoing service.

Service action

Configures the Firebox to allow or deny this type of service

traffic through the firewall.

Restrict to remote computers

To put a limit on the scope of the service, add the IP addresses

of the computers or networks outside the firewall to which this

service applies.

Restrict to local computers

To put a limit on the scope of the service, add the IP addresses

of the computers or networks inside the firewall to which this

service applies.

Adding a custom incoming service manually

You can add a custom service without using the wizard.

1 To connect to the System Status page, type https:// in the

browser address bar, and the IP address of the Edge trusted

interface.

The default URL is: https://192.168.111.1

2 From the navigation bar, select Firewall > Incoming.

3 Scroll to the bottom of the page.

4 Below Custom Services, click Add Service.

The Custom Service page appears.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 253 254

No comments

Watchguard Wireless Router User's Guide Page 106