Watchguard Wireless Router User's Guide Page 60

  • Download
  • Add to my manuals
  • Print
  • Page
    / 254
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 59
Changing Your Network Settings
46 WatchGuard Firebox X Edge
4 Follow the instructions on the screens.
The Network Setup Wizard has these steps:
Welcome
The first screen describes the purpose of the wizard.
Configure the external interface of your Firebox
This screen asks the method your ISP uses to set your IP address.
For more information, see the subsequent section in this guide,
“Configuring the External Network.”
Configure the external interface for DHCP
If your ISP uses DHCP, type the DHCP information that your ISP
gave you. For more information, see “If your ISP uses DHCP” on
page 47.
Configure the external interface for PPPoE
If your ISP uses PPPoE, type the PPPoE information that your
ISP gave you. For more information, see “If your ISP uses PPPoE”
on page 49.
Configure the external interface with a static IP address
If your ISP uses static IP addresses, type the static IP address
information your ISP gave you. For more information, see “If
your ISP uses static IP addresses” on page 48.
Configure the trusted interface of the Firebox
On this screen, type the IP address of the trusted interface. For
more information, see “Configuring the Trusted Network” on
page 53.
The Network Setup Wizard is complete
Configuring the External Network
You must configure your Firebox® X Edge external network manu-
ally if you do not use the Network Setup Wizard.
When you configure the external network, set the method your
Internet Service Provider (ISP) uses to give you an IP address for
your Firebox. There are three methods ISPs use to assign IP
addresses:
DHCP - Network administrators use the Dynamic Host
Configuration Protocol (DHCP) to give IP addresses to
computers on their network automatically. With DHCP, your
Page view 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 253 254

Comments to this Manuals

No comments