Watchguard Wireless Router User's Guide Page 56

  • Download
  • Add to my manuals
  • Print
  • Page
    / 254
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 55
Configuration and Management Basics
42 WatchGuard Firebox X Edge
Follow these steps to set the Firebox to the factory default settings:
1 Disconnect the power supply.
2 Hold down the Reset button, on the front of the Firebox.
3 Connect the power supply while you continue to hold down the
Reset button.
4 Continue to hold down the button until the yellow Attn light
comes on and stays on. This shows you that the Edge has been
successfully reset.
NOTE
Do not try to connect to the Edge at this time. Start the Edge one
more time, as the subsequent steps show.
5 Disconnect the power supply.
6 Connect the power supply again.
The Power Indicator is on and your Edge is reset.
Restarting the Firebox
You can restart the Firebox® X Edge from a computer on the trusted
network. You can also restart the Firebox from a computer on the
Internet connecting to the Firebox external interface.
The Firebox restart cycle is up to 40 seconds. During the restart
cycle, the mode light on the front of the Firebox turns off and then
turns on again.
Local restart
You can locally restart the Firebox X Edge with two methods: use
the Web browser or disconnect the power supply.
Using the Web browser
1 To connect to the System Status page, type https:// in the
browser address bar, and the IP address of the Edge trusted
interface.
The default URL is: https://192.168.111.1
Page view 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 253 254

Comments to this Manuals

No comments